top of page
Tips & Techniques
Maximize your use of Detail Junkees products with these little tips.
01
Photo Etch Backing Removal: Many pieces can be removed by simply peeling them off. Our stainless steel parts are pretty rigid. However, the best thing to do is drop them in a bath of lacquer thinner. The thinner will not only dissolve the rubber, but also clean the metal from any chemical residue.
Polishing Your Photo Etch: http://www.italianhorses.net/tutorials/Photoetch/pe.htm
02
03
Gluing your Photo Etch: Scale Auto Article
04
Decal Use: For best results use minimal water to release decal paper from backing. Moisten area to be covered and slide decal into position. Clear coat to permanently seal them.
bottom of page